Modelling culverts in TELEMAC: code validation with scale flume model of Doelpolder
Smolders, S.; Vercruysse, J.B.; Spiesschaert, T.; Geerts, S.; Mostaert, F. (2019). Modelling culverts in TELEMAC: code validation with scale flume model of Doelpolder. Version 3.0. FHR reports, 18_145_1. Flanders Hydraulics Research: Antwerp. VII, 30 pp.
A scale model of part of the inlet culvert construction of Doelpolder was available after project 15_073 (Scale model test on combined in- and outflow construction of Doelpolder). Additional flume tests were done with this scale model in four different setups: without weir logs and without a trash screen, with weir logs and without a trash screen, without weir logs and with a trash screen, and with weir logs and with a trash screen. For eight different sets of fixed water levels before and after the culverts the discharge for each setup was measured. These measured discharges are then compared with calculated discharge, based on the same water levels and construction parameters with a set of discharge through a culvert formulations built in the code of TELEMAC. The calculated discharge are in good agreement with the measured ones. This shows that the culvert formulas present in TELEMAC are capable of reproducing the discharges through the complex culvert structures of the Flemish flood control areas.
All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy
